LED Profile Installation Guide
LED Profile Installation Guide
There is potential danger of electrical shock when operating electrical components.
Do not install in a sealed environment – allow for heat dissipation and adequate ventilation
Install Aluminium LED Profile in properly rated environment
Aluminium LED Profile stock length is 1.8 mNote: Aluminium LED Profile is rated IP20; it is recommended to remove lens cover for cleaning on a scheduled basis
Terminations
Factory Termination
Aluminium LED Profile is assembled and does not require any mechanical work. Connect lighting as per LED Ribbon wiring diagrams.
Field Termination
1. Lay out and measure the length of the LED Ribbon
Tip: Cut the track and lens in place for a flush edge
3. Apply silicone adhesive on to track
4. Place LED Ribbon light on the flat surface in the channel
5. Use masking tape to fasten LED Ribbon in place while adhesive cures
6. Allow adhesive minimum of 24 hours to dry; it takes 7 days to fully cure
Tip: Align multiple aluminium tracks end to end to connect pieces longer than stock length
7. Fit the lens onto the aluminium track
8. If a hole doesn’t already exist, drill one through an end cap to allow LED lighting lead wires to pull through
9. Fit end caps onto the finished profile
Mounting
Mounting Clip
1. Mount track clips onto surface with flathead screw
2. Snap on Aluminium LED Profile to clips
Leave a Reply
You must be logged in to post a comment.